• Kelly Reeve

Proper Co2 Detector Placement


Properly Placing Your Carbon Monoxide Detectors


If you don’t have carbon monoxide detectors in your home, you should absolutely install them. And if you do already have them, you’ll want to be sure they are in the proper locations in your home. If you have any fuel burning heater or appliance, fireplace, or attached garage, you must have a carbon monoxide (“CO”) detector/alarm in your home. The installation locations will vary by manufacturer for their specific type and style of detector, and you should read and follow your manufacturer’s instructions for your specific unit. But here are some general guidelines for where to place your CO monitors, so that they are the most effective in keeping your family safe . . . and where you should NOT place your CO detectors.

WHERE TO PLACE THEM

The International Association of Fire Chiefs recommend a carbon monoxide detector be installed on every floor of your home, including the basement. A detector should be located within 10 feet outside of each bedroom door, and there should be one near or over any attached garage. It is important that your CO detectors be close enough to the bedrooms so that the sound from the alarm is loud enough to wake up the person in the room. Because carbon monoxide is slightly lighter than air (and because air with CO is typically warmer, and therefore rises) your detectors should be placed on a wall about 5 feet above the floor. Some CO detectors can be plugged directly into wall electric outlets, so you may be tempted to plug them into wall outlets which are only a foot or two off of the floor. But for the best effectiveness, they should instead be located about 5 feet off of the floor. If your manufacturer recommends it for your particular model, your CO detector may be placed on a ceiling.

WHERE NOT TO PLACE THEM

The following are places where it is NOT recommended to place your CO detectors:

  • A CO detector should not be placed within 15 feet of heating or cooking appliances.

  • CO detectors should not be placed in or near humid areas, such as bathrooms.

  • Do not install CO detectors within 15-20 feet of any furnace or fuel-burning appliances, as these appliances may emit a small amount of carbon monoxide upon start-up, and give false alarms.

  • Do not place your CO detectors in areas where they will be damaged by children or pets.

  • Do not install CO detectors in direct sunlight or areas subjected to temperature extremes, such as crawlspaces, unfinished attics, and porches.

  • They should not be installed behind curtains or other obstructions.

  • And your CO detectors may not function properly if installed near ceiling fans, heat vents, air conditioners, fresh air returns, or open windows.

OTHER CONSIDERATIONS

The life expectancy for your CO detectors will be specific to each manufacturer’s recommendations. Most detectors should be replaced every 5-6 years. And if you wait longer than 5-6 years, then you can be living with a false sense of security. Also, some CO detectors can be wired into your existing home security or fire panel which is monitored by a central station. With your CO detectors wired in to a central monitoring station, the central station can be alerted to the high concentrations of CO gas and can send the proper authorities to investigate possible carbon monoxide poisoning. This can be extremely valuable in case your family has become overcome from the effects of CO, or are sleeping soundly, or if no one is at home.

#SafetyConcern #HealthHazards #2018HomeInspections #SacramentoInspection

we are only a phone call away

1-916-256-2022
CALL US NOW
​for an inspection quote

© 2020 by Sierra Inspection Services| All Rights Reserved

3941 Park Dr. Suite 20-486

El Dorado Hills, CA 95762 (Sacramento area)

Call us +1-916-256-2022 or email kelly@sierrainspections.com

We carry E&O and Gen. Liability Insurance for your peace of mind

  • LinkedIn Social Icon
  • Facebook Social Icon